SAVE $200 ON A NEW SMART PACKAGE UNTIL MAY 15! Plus get a free upgrade to the integrated screen controller!
This DTG2 package has integrated intelligence with the included sensor package.
- DTG2 ROV
- Controller with 75M tether
- Smart chargers
- Intelligent sensor package complete with auto depth and auto heading
- Buoyancy weight set
- Operator manual
- Robust Carrying Case
- Heavy Duty tether reel with bearings and electrical slip ring for easy tether management
- Integrated Super Bright Screen
- 1 Year Warranty
High powered rare earth magnetic couplers means there are no dynamic seals on this system, for maximum leak protection.
Well protected 63mm diameter propellers prevent debris from binding the output shaft.
The very safe battery-operated 19.2 VDC onboard electrical system reduces tether diameter and eliminates power loses through long power feeds. A smart charger simply plugs into the back of the ROV when back on shore and indoors. Onboard sensors monitor the motor's status and will immediately cut power if there is a fault. Additional sensors track the battery and warn the operator of low levels. A low battery is not of any concern as the ROV can simply be pulled out of the water with the tether. Normal battery life is 5 to 8 hours of run time with a recharge time of 3 hours
A 480 line colour camera rotates from the center of the ROV to take advantage of the center window and gives the operator a 270 degree vertical field of view. The camera is tracked by an LED floodlight. This feature allows the operator to look in any direction whether it be straight up at the hull of a boat or straight down at the seabed while driving forward.
The DTG2 is sized for good stability in the water, but small enough to transport by hand to difficult locations. At 18.8 lb. you may lower it into the water by the tether over the side of the boat or even from a very high vantage point, such as a bridge. The nominal buoyancy of the ROV is set to neutral. It can be adjusted with an included set of stainless steel weights to fine tune the unit according to your preference and water conditions.
Commanding the DTG2 is simple using the lightweight and very portable controller. This familiar style of controller will ease the learning curve normally required to pilot ROVs.
The tethers are integrated into the controller and can be swapped out on the ROV if required. The tether is plugged into the rear face of the ROV at the water proof bulkhead and can easily be removed.